If you want a higher shine on your cleaned floor, you can make a paste from 50/50 water and baking soda and spread it gently over the marble. Allow it to dry, then remove the residue with more water and a soft cloth.
Also question is, what can I use to clean and polish marble?
Mild soap and hot water will do just fine. Wipe sudsy water on the counter with a soft cloth or sponge. This will remove dirt but won’t heal any etching or stains. You can give your marble a little protection from stains and etching by using spray sealant at least once a month.
People also ask, how do you keep marble floors clean and shiny?
It is important that the cleaning solution used on marble be pH neutral. Do not use acidic cleaners on your marble or it will scratch and lose shine. This means no vinegar! Clean your marble floors with a highly diluted mixture of ammonia and water or with a highly diluted mixture of dish soap and water.
Will baking soda damage marble?
Baking soda is alkaline so you should only use it with caution. It is also a mild abrasive, so you need to use it gently rather than applying elbow grease. Because of these factors, a baking soda cleanser should not be used on marble every day. Frequent use could dull your marble countertop.
What is the best marble polish?
A marble polishing powder is the best and easiest method to remove these etch marks from polished marble. We recommend using MB stone care’s MB-11 marble polishing powder because we have used it successfully many times and is well recommended on amazon and marble specific third party sites from around the world.
Is Dawn dish soap safe for marble?
Most of the time, a solution of dish soap and warm water is all that’s needed to keep marble looking new. … You can also clean marble floors with a solution of dish soap and warm water—and you don’t need to get down on your hands and knees.
How do you polish marble after cutting?
Change to a 400-grit diamond disk to begin polishing the edge of the marble. You should notice a slight shine to the edge after using this disk. Switch to an 800-grit disk for a couple of passes, then move to a 1,500-grit disk. These create a bright, polished shine on the edge of the marble.
